Specifically, Zulu OpenJDK is a very good alternative, offering thoroughly tested and verified builds, which are free and open source as well. Installing non-official OpenJDK 11 Alpine from an OpenJDK vendor. For installation procedure, so this post. However, you won't be running "native Alpine" anymore. This is a fairly easy procedure, which will allow you to run any Linux software on Alpine. ![]() Installing proper glibc on the Alpine container. It’s not production-ready because it hasn’t been tested thoroughly enough to be considered a GA build. Navigate to the Software Downloads page on the Red Hat Customer Portal. The Alpine Linux build previously available on this page was removed as of JDK 11 GA. However, unfortunately, such build is not currently available. So you'll need an OpenJDK 11 Alpine build, specifically. As a consequence, standard Linux software that is built on non-Alpine distibutions, will usually be linked against glibc and cannot be ran on Alpine, without installing a glibc compatiblity layer. You could verify this using ldd java.Īlpine Linux is using musl-libc for its libc (standard C library) implementation, in contrast to most other Linuxes which are using glibc, GNU's C library. Then open another command prompt and type java version, you will see: That means you have successfully setup OpenJDK 11 on your computer. Important Notice Since version 11.0.3 Bell Soft provides binary packages of OpenJDK 11 for Linux x86. Compiled binaries are available at the release page. Then type the following command to update JAVAHOME (in Command Prompt with administrator right): setx -m JAVAHOME 'g:JDKOpenJDKjdk-11.0.2'. OpenJDK 11 for Linux x86 (IA-32) This repository provides builds of OpenJDK 11 for Linux x86 (aka IA-32) created with the build scripts by AdoptOpenJDK. The reason you're getting java: not found is likely due to dynamic linking failure. Extract the downloaded zip file to a directory. opt/openjdk-11/bin:/usr/local/sbin:/usr/local/bin:/usr/sbin:/usr/bin:/sbin:/binīut when I run java itself, I get: / # java -versionĪnd I get kicked out of the container. ![]() echo /opt/openjdk-11/bin:/usr/local/sbin:/usr/local/bin:/usr/sbin:/usr/bin:/sbin:/bin Tar -extract -file /openjdk.tgz -directory "$JAVA_HOME" -strip-components 1 \Īfter that, I can confirm that a few things seem correct: / # ls -lah $JAVA_HOME/bin/java ![]() I'm trying to build an alpine docker image with openjdk 11.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |